User's Manual

User Manual for AyCare AyTerminal
V2.1 AyCare application
4.4.1Activation Time
The purpose of the “Activation time” menu (see Figure 4-22) is:
• Enable/disable the activation time. In case of activating the activation time the mode will be
active only for the defined time (e.g. 1 hour, between 12:00:00 and 13:00:00). When the
end time is reached the mode becomes idle.
• Defining an activation start time (see Figure 4-23) (e.g. 12:00:00)
• Defining an activation end time (see Figure 4-24) (e.g. 13:00:00) for a mode on a daily
basis.
Upon selecting one of the “Start” or “End” menu items, the time can be entered in a time editor.
The time format is 24h (hh:mm:ss).
The colons will be displayed after the second and fifth digits.
Adding a new digit in the input area can be done by navigating through the displayed characters
(right side of the screen) by using the up/down navigation buttons until the needed character is
selected and then pressing the OK button (right button).
To leave one of the two previous screens and to set the value, OK item must be selected and the
OK button (right button) must be pressed.
Activation time
Start
End
Active
Start
End
Activation t
Active
Figure 4-22 Activation time menu
12:0_
Start time
9
2
1
0
12:0_
Start time
0
2
1
Figure 4-23 Activation time – Set start time screen
13:0_
End time
9
2
1
0
13:0_
End time
0
2
1
Figure 4-24 Activation time – Set end time screen
The activation time is applied to the mode as long as the “Active” menu item is activated. To
disable the activation time, the “Active” checkbox in the “Activation time” menu must be unchecked
(see Figure 4-22).
Note! Only one mode can have activation time active.
Page 27 / 50