User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
the temperature sensor will have lower environment temperature accuracy due to the battery
charging.
2.1.10OLED display
The AyTerminal has a white OLED display with 128x96 pixel resolution which is also the active
display area used for the screen layouts. In standard mode the used font is Tahoma 15x16
proportional and in jumbo mode the font Tahoma 23x24, each font consisting of maximum 128
characters. These fonts allow English and German user interfaces. All characters that are not
supported by the character set of the used font will be shown as ‘?’.
2.1.11Battery charging
The AyTerminal can be connected to a charger either when the device is switched on or off. It
takes approximately three hours to fully charge the battery.
2.1.11.1Connecting a charger & AyTerminal switched off
If the device is switched off and a charger is connected then the charging battery symbol will be
shown on the display (see Figure 2-6). The AyTerminal can be turned on by pressing long the
central button.
Charger
Connected
Charger
Connected
Charging
Battery
Charging
battery
Charging
finished
Charging
finished
Charging
Interrupted
Charging
interrupted
Figure 2-6 Charging possible states of AyTerminal
2.1.11.2Connecting a charger & AyTerminal switched on
If the device is switched on and a charger is connected, the charging battery symbol will be shown
while the status bar is shown, see Figure 2-7. The AyTerminal will work normally like it does
without charger connected.
Page 12 / 50