Installation Instructions

Installation Instructions
Document No. 129-802
October 18, 2012
ASK80.1 Footmount Kit
for GQD Actuators
Item Number 129-802, Rev. AA Page 1 of 4
EA1368R1
A
C
D
B
E
F
Product Description
This kit contains the parts needed to mount an
OpenAir™ GQD Damper Actuator for a foot or frame
mount to a damper.
Contents
A Mounting plate
B Lever
C Bushing
D Thread-forming mounting screws (3)
E Ball Joints (2)
F Self-drilling Tek screws (4)
Product Number
ASK80.1
Warning/Caution Notations
WARNING:
Personal injury or loss of life
may occur if you do not follow
the procedures as specified.
CAUTION:
Equipment damage or loss of
data may occur if you do not
follow the procedures as
specified.
Required Tools
• Electric drill
• 3 mm hex key (included with GQD Actuator)
Expected Installation Time
45 minutes
Prerequisites
• Determine what side and in what orientation
the GQD Actuator should be mounted
before assembling the bracket. (See
Figure
4
and Figure 5.)
• After determining the desired actuator
position on the bracket, assemble the
bushing to the bracket with two thread-
forming screws. The bushing should always
be assembled so that the protruding side
faces the actuator. See
Figure 1.
• Drive one of the thread forming screws into
one of the two lower holes in the bracket
leaving approximately 5 mm (.197) under
the head of the screw exposed to provide
anti-rotation for the actuator. See
Figure 1.
EA1380R1
0.20
(5)
Actuator
Figure 1. Anti-rotation Screw Location.