Installation Instructions

Document No. 129-262

September 30, 2009

ASK76.1U Conduit Adapter

Item Number 129-262, Rev. BA Page 1 of 2

Product Description

This kit provides an adapter that allows for a conduit

connection to the OpenAir™ GDE/GLB models.

Contents

This kit contains one conduit adapter and a flat head

screw.

Product Numbers

ASK76.1U

Required Tools

• Flat head screw driver

• 4 mm hex wrench

Expected Installation Time

10 minutes

Installation Conventions

WARNING

Personal injury/loss of life may

occur if you do not follow a

procedure as specified.

CAUTION

Equipment damage or loss of

data may occur if you do not

follow a procedure as specified.

Prerequisites

Provide a conduit connector.

Installation

Loosen and remove the stop set screw and nut from the

actuator. See Figure 1

Figure 1.

Attach the desired conduit connector to the base of the

conduit adapter.

NOTE: A second opening in the base of the

adapter is available by removing the

knock-out.

Figure 2.

Thread the cable through the opening(s) in the conduit

adapter.

Set the actuator in the adapter so that the actuator

fits into the guide on the adapter.

PAGE 1
Installation Instructions Document No. 129-262 September 30, 2009 ASK76.1U Conduit Adapter Product Description This kit provides an adapter that allows for a conduit connection to the OpenAir™ GDE/GLB models. Contents This kit contains one conduit adapter and a flat head screw. Product Numbers ASK76.1U Figure 1. Required Tools • Flat head screw driver • 4 mm hex wrench Expected Installation Time Attach the desired conduit connector to the base of the conduit adapter.
PAGE 2
Document No. 129-262 Installations Instructions September 30, 2009 NOTE: The actuator mounting bracket fits between the guides in the lower back of the conduit adapter. Figure 3. Fasten the actuator to the adapter with the screw provided. See Figure 3. Mount the actuator and adapter following the installation instructions that come with the actuator. Figure 4.