Installation Instructions

Document No. 129-261

September 30, 2009

OpenAir™ Weather Shield Kits

Item Number 129-261, Rev. 300 Page 1 of 2

Product Description

Kits provide additional protection for GCA, GBB,

GIB, GMA and GEB OpenAir™ actuators in an

outside installation.

Contents

Weather shield, base plate with factory-installed

insulation, anti-rotation (mounting) bracket:

ASK75.1U: 15 TEK self-drilling screws

ASK75.3U: 13 TEK self-drilling screws

Product Numbers

ASK75.1U:

GCA, GBB, GIB

ASK75.3U:

GMA, GEB

Required Tools

• 1/4-inch power nut driver

Expected Installation Time

45 minutes

Prerequisites

Refer to the installation instructions that come with

the actuator for additional details on the function and

wiring of the actuator.

Obtain appropriate outdoor electrical fittings needed

for connection to the 1/2-inch knockout.

Mounting Position

Figure 1. NEMA 3R Rating in this Mounting Position

Only, for Both Models.

Figure 2. Dimensions of the ASK75.1U Weather Shield in Inches (Millimeters).

PAGE 1
Installation Instructions Document No. 129-261 September 30, 2009 OpenAir™ Weather Shield Kits Product Description Kits provide additional protection for GCA, GBB, GIB, GMA and GEB OpenAir™ actuators in an outside installation. Contents Weather shield, base plate with factory-installed insulation, anti-rotation (mounting) bracket: ASK75.1U: 15 TEK self-drilling screws ASK75.
PAGE 2
Document No. 129-261 Installation Instructions September 30, 2009 Figure 3. Dimensions of the ASK75.3U Weather Shield in Inches (Millimeters). Figure 4. Mounting the Actuator in Weather Shield for Both Models. Installation 6. Attach the actuator to the damper shaft using the instructions that come with the actuator, and secure the anti-rotation (mounting) bracket with two of the TEK screws. 7. Holding the weather shield from the bottom, align the edges with the base plate.