User guide
2322
Operating Your Hearing
Instrument – Programmable Features
Refer to the feature card included with this manual to determine
the programmable features your hearing instrument is equipped
with. Programmable features are listed on the right column of the
feature card (Fig. 11):
IN-THE-EAR
FEATURE
CARD
Volume control
Learning volume preference
Program button
Directional microphone
Telecoil
AutoPhone
®
ePocket
®
remote control
e2e wireless
®
Push button on/off
Power on delay
Low battery indicator
Volume control
alert tones
Program change
alert tones
OPTIONAL FEATURES
PROGRAMS
PROGRAMMABLE
FEATURES
Program number Listening environment
Refer to the ITE User Manual for information on
Optional Features and Programmable Features.
Use the
type of
battery
shown
below
1
2
3
4
Microphone
Vent
Program button
Microphone
Volume control
Battery
compartment door
Programmable
Features
Fig. 11: FEATURE CARD
Programmable features section circled
Wireless Functionality
Your hearing instrument may be equipped with wireless
functionality. This provides synchronization between two
hearing instruments. If you change the program or volume on
one instrument, the other is automatically changed. In addition,
wireless technology automatically adjusts the system to change
both hearing instruments simultaneously to adapt to different
listening situations. The wireless functionality also enables use of
an optional remote control.
Note: The performance of the e2e wireless® could be temporarily
affected when in close proximity to electromagnetic noise
sources, such as a computer monitor or television. Move
away from the noise source if you experience difficulty.
Technical information for e2e wireless function:
Operating frequencies: flow = 115 kHz, fhigh = 120 kHz; Rated
H-field strengh (maximum): –11,5 dB µA/m at 3 meters.
This Category II radiocommunication device complies with Part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause interference,and (2) this
device must accept any interference, including interference that
may cause undesired operation of the device.
This Class B digital apparatus II radiocommunication device
complies with Part 15 of FCC Rule. Operation is subject to
the following two conditions: (1) this device may not cause
interference,and (2) this device must accept any interference,
including interference that may cause undesired operation of the
device.
The above applies to CIELO® 2, ARTIS® 2, ACURIS®, CENTRA®,
and Motion 701, 501, 301. All other remote control compatible
custom hearing instruments use e2e wireless 2.0.
Technical information for e2e 2.0 wireless function:
FCC: SGI-WL002ITE IC: 267AB-WL002
Operating frequency : Fc = 3.28 MHz; Maxium field strength: –7
dB µA/m at 10m meters.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular