Installation Instructions

ManualsBrandsSiemens ManualsSensors TemperatureImmersion Well Temperature Sensor Installation Instructions

Document No. 129-462

September 10, 2009

Immersion Well Temperature Sensor

Item Number 129-462, Rev. BA Page 1 of 2

Product Description

The Immersion Well Temperature Sensor provides a

temperature input to a controller. It threads into a coupling

on a piping system.

Contents

• Immersion well

• Sensing element

• Pulling elbow for wiring connections

Product Numbers

Product Number Sensing Element

QAE2030.XXX

10K

Ω

NTC Type II

QAE2032.XXX

10K

Ω

NTC Type III

QAE2012.XXX

Ω

Pt (385

)

QAE2020.XXX

Ω

Ni Siemens

QAE2021.XXX

Ω

Ni JCI

.XXX

U (Insertion Length in Inches [mm])

.005

2.5 (63.5)

.010

4 (101.6)

.015

6 (152.4)

Required Tools

• Power screwdriver with 1/4-inch (6 mm) hex

extension or medium flat-blade screwdriver

• 1-1/4 inch (32 mm) open-end wrench or

equivalent adjustable wrench

• Medium crescent wrench

• Pipe sealant

• Wire stripper

Expected Installation Time

3 hours

Prerequisites

• The appropriate field wiring within the maximum

wiring run length for the individual field panel or

equipment controller must be in place.

• All wiring must comply with National Electric Code

(NEC) and local regulations.

• A 1/2-inch (13 mm) NPT mounting coupling must

be installed in the piping system at the sensor

location. Figures 1 and 2 show two types of

installation in a pipe joint.

Figure 1. Pipe Surface Installation.

Figure 2. Pipe Joint Installation.

Summary of content (2 pages)

PAGE 1
Installation Instructions Document No. 129-462 September 10, 2009 Immersion Well Temperature Sensor Prerequisites Product Description The Immersion Well Temperature Sensor provides a temperature input to a controller. It threads into a coupling on a piping system. Contents • Immersion well • Sensing element • Pulling elbow for wiring connections • The appropriate field wiring within the maximum wiring run length for the individual field panel or equipment controller must be in place.
PAGE 2
Document No. 129-462 Installation Instructions September 10, 2009 Installation NOTE: It is not recommended or necessary to separate the well and the pulling elbow to install the sensor assembly. The pulling elbow should only be removed to replace a damaged or defective sensing element. 1. Clean any dust away from the coupling for the well. 2. Apply pipe sealant to the threads of the well and insert the entire sensor assembly into the coupling. 3. 4. Hand-tighten the sensor assembly.