Installation Instructions
Document No. 129-489
Installation Instructions
August 13, 2018
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models
as design improvements are introduced. Teflon is a trademark of DuPont. Other product or company names mentioned herein may be the
trademarks of their respective owners. © 2018 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089
+ 1 847-215-1000
Your feedback is important to us. If you have
comments about this document, please send them
to SBT_technical.editor.us.sbt@siemens.com
Document No. 129-489
Printed in the USA
Page 2 of 2
e. Install wiring conduit, flex or rigid, between
the field utility box and the pulling elbow.
f. Run field wiring through the conduit to the
pulling elbow and connect the field wiring to
the sensor leads using the wire nuts
provided.
NOTE: In applications where condensate may
accumulate (chillers, low temperature
sensing, etc.), seal all wire nut
connections with RTV (part number
535-495), ordered separately.
g. Reinstall the gasket and cover onto the
pulling elbow.
7. Reconnect the wiring lead disconnected in
Step 1.
The installation is now complete