Installation Instructions

Document No. 545-405
Installation Instructions
Rev. 7, February, 2002
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their
respective owners. © 2002 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc.
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Your feedback is important to us. If you have
comments about this document, please send
them to [e-mail]
Document No. 545-405
Printed in the U.S.A
.
Page 4 of 4
6. To reposition or remove the point module,
push the point module toward the
termination block and press the module
housing release tab located at the left-hand
side of the point module. Then tilt the point
module (Figure 6).
The installation is now complete (Figure 7).
Figure 6. To Reposition or Remove a Point Module.
Figure 7. Point Modules and Termination Blocks
Installed (MBC Shown).
For MBCs with styled doors and RBCs
with windowed doors
1. Leave the layout sheet in the literature pocket
located at the bottom of the field panel.
2. Remove the perforated blank-out papers from
the view panel to expose each installed module
location (Figure 8).
Figure 8. Exposing Module Locations.