User Guide

FIN Builder Graphics Tool
Using the FIN Builder Graphics Tool
24
Siemens Industry, Inc.
Kiosk Mode User Guide
A6V10455247
Building Technologies
2017-06-30
NOTE:
Any value can be selected for the
Fault state. However, a low value, such as 15%, is
recommended so that the failure or other condition is evident to the user.
7. Leave the other Alpha level options unchanged and click the Apply button.
8. Repeat this procedure for all bound components that you want to display as
degraded when the point (or device) they are bound to fails.
Example 2: Degrading a Gauge Component
In this example, a Gauge component is set up to degrade when the bound point is
Failed.
1. Add a Gauge Component to your graphic.
2. Bind it to the desired device point. In our example, we are using an FLN device
point AOV1.
Figure 5: Degrading a Gauge Component - Binding a Gauge Component to the Device Point.
3. Bind this same point to the Alpha property.