User Guide

FIN Builder Graphics Tool

Using the FIN Builder Graphics Tool

Siemens Industry, Inc.

Kiosk Mode User Guide

A6V10455247

Building Technologies

2017-06-30

Getting the Siemens Connector Revision Graphic

Downloading from Partner Extranet Site

1. Open Partner Extranet web site and navigate to \Products\Building Automation,

Engineering Tools section, and then select FIN Builder.

2. From the Resource Center, right-click FIN Builder Connector (.flb – 1 MB) and then

extract FIN_Lib.zip file. The following files are extracted:

– FINSiemensLibrary.flb

– Siemens Connector Installation ReadMe.pdf

– \FIN\HTML\SiemensConnectorRevision.html

– \FIN\Projects\SiemensConnectorRevision.finp

– \FIN\Projects\SiemensConnectorRevision.jpg

3. Copy the graphic (.html, .finp and .jpg) files to the corresponding directories on

Drive B:\ of the field panel.

Connecting to a Device

Once the Siemens Connector is installed, you can add Siemens field panels to FIN

Builder. This will allow you to connect to those devices and bind information from those

devices to components in FIN Builder graphics.

 To connect a device to FIN Builder:

1. From the Devices menu, move your cursor over Available Devices and select Add

Device. A New Device selection displays. Select New Device.