User Guide

FIN Builder Graphics Tool
Using the FIN Builder Graphics Tool
35
Siemens Industry, Inc.
Kiosk Mode User Guide
A6V10435686
Building Technologies
2017-06-30
 A drop-down list displays.
7. Use the checkmarks to the right of the points to select all the points that you want
to relativize, or deslect all the points that you do not want to relativize.
8. Click the blue checkmark in the upper right corner to indicate that you are done.
 The Mapping window displays the relativized points.
 The
Equipment window displays the unrelativized points, organized by device
folder.
 The data is now ready for use with Actions or the Equipment Combo control.
NOTE:
If you want to use a point that is not relativized, you must drag and drop it from the
Equipment pane or the Device pane.
Default Settings
It is recommended that you use the following settings as your default settings for all
graphics.
A FIN Builder graphic's default poll rate interval is one (1) second. This means that the
graphic will attempt to obtain the current value for each bound point every second. For
some systems, this may be too frequent. The recommended poll rate interval is 15
seconds.
By default, FIN Builder is set to Basic Mode. It is recommended that you set FIN
Builder to Advanced Mode in order to access all of the available FIN Builder features
and components.
These settings can be saved as default settings and will apply to all new graphics.
To adjust these settings:
1. Select the canvas (graphic background).
2. In the properties settings, adjust the poll rate to the desired value.
3. Change the mode to Advanced Mode.
4. To make this the default for every graphic, select the Make Default button after
adjusting the poll rate.