User Guide

FIN Builder Graphics Tool

Using the FIN Builder Graphics Tool

Siemens Industry, Inc.

Kiosk Mode User Guide

A6V10435686

Building Technologies

2017-06-30

Relativizing MS/TP Devices

You can relativize graphics from one BACnet FLN Device to other BACnet FLN

Devices. With Siemens BACnet devices the application point mappings are similar

across devices.

For example, Room Temperature always has an object identifier of

0,4. Therefore, the

points will relativize easily from device to device.

Relativizing ALN and FLN Devices

This is strongly

NOT recommended. However, if you want to relativize from mixed

devices, the object instance must be the same in both devices.

For example, you must make sure the object identifiers are the same for all devices

being relativized. If you are relativizing to the Room Temperature point in a PTEC, you

must make sure that the Room Temperature point exists in the panel and has the

same object identifier (

0,4)

Using the Relativization Feature

 In your FIN project:

1. Drag the appropriate devices from the Devices pane and drop them onto the

Equipment pane.

2. Drag the appropriate points from one of the devices and drop them onto the

Mapping pane.