Installation Instructions

Document No. 553-671
Installation Instructions
February 1, 2011
Page 2 of 4
2. Attach one end of the Ethernet cable to the
connector underneath the circuit board inside the
controller opening cover. Secure the cable inside
the cover, using the cable restraints and the
notch on the side of the cover:
PXM0012R1
3. For Siemens Compact 16 and 24 controllers,
attach the ribbon cable (PXA-HMI.CABLEP5) to
the back of the mounting kit cover. Plug the free
end of the cable into the connector (10-pin)
located at the top end of the circuit board:
U14 U15U8 U9 U10 U11 U12 U13 AO2 AO3AO1U1624V 24V
PXM0013R1
4. Siemens Compact 36 and Modular controllers
do not require the ribbon cable and can be direct
connected:
PXM0014R1
U14 U15U8 U9 U10 U11 U12 U13 AO2 AO3AO1U1624V 24V
5. Insert the lower two cover tabs into the slots
located at the bottom of the controller opening:
U14 U15U8 U9 U10 U11 U12 U13 AO2 AO3AO1U1624V 24V
PXM0015R1
6. Push the upper prong into the upper slot on the
controller opening:
U14 U15U8 U9 U10 U11 U12 U13 AO2 AO3AO1U1624V 24V
PXM0016R1