Installation Instructions

Installation Instructions
Document No. 553-684
May 5, 2010
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their
respective owners. © 2010 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Your feedback is important to us. If you have
comments about this document, please send
them to [e-mail]
Installing the Migration Backplane
DANGER:
Shutting down the service box may not
disconnect all high voltage I/O.
If no means for disconnecting are available,
leave the existing terminals connected to
the wire.
WARNING:
This installation should only be done by a
qualified electrician or an authorized
Siemens Industry, Inc. representative.
1. Secure the backplane on the four mounting
studs using mounting nuts previously set aside.
2. Ensure service box power switch is off and
connect MEC Power Termination Block to
service.
3. Where necessary, apply new logo to door over
old logo.
The installation is complete.
Figure 1. MEC Small Migration Kit.
Document No. 553-684
Printed in the USA
Page 2 of 2