Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationAPOGEE Wiring Guidelines for Field Panels and Equipment Controllers

Document No. 545-406

January 23, 2004

Page 2 of 4 Siemens Building Technologies, Inc.

Installation

NOTE: All PTMs have a piece of color-coded tape

affixed to the right side of the identification

window to identify the module type.

AO-P modules have pink tape.

Inserting the Module Labels

Do the following for each AO-P module being

installed:

1. Use the point module address (for example,

2.0.1.1) to identify the correct label on the label

sheet. For example:

OR2HWV

HW VALVE

2.0.1.1

NOTE: If pre-addressed labels have not been

supplied, identify each point module by

legibly writing the following information for

each point on the paper label:

Name, Description, and Address.

2. Remove the label from the perforated sheet.

3. Fold the label to double thickness and insert it

into the slot on the left side of the module

(Figure 2).

The label should fit snugly under the module

identification window.

Figure 2. Labeling the Point Module.

Inserting Address Keys and Address

Markers

An address key is inserted into each AO-P point

module to provide a unique address to both the

Open Processor and the point database.

An address marker snaps into each connector block.

Should it become separated from the point module,

use the address marker to match the connector

block to the appropriate point module.

NOTE: APOGEE address keys are sequentially

numbered (for example, 001, 002, etc.).

Pre-APOGEE address keys are numbered in

multiples of 4 (for example, 004, 008, etc.).

Do the following for each AO-P module and

connector block being installed:

1. Match point module address with the

corresponding address key.

For example, module address 2.0.1.1 uses key

number 001.

CAUTION:

The point address on the front label

must be the same as the address key

number.

2. Detach the appropriate address key from the

spine.

3. Insert the address key into the slot located in

the upper right corner of the point module

(Figure 3).

4. Snap the address marker into the connector

block (Figure 3).

Figure 3. Inserting the PTM Address Key and Marker.