Installation Instructions

Document No. 553-148
DIN Migration Backplane Kit for UC or FLNC Installation Instructions
January 27, 2009
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their
respective owners. © 2009 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc.
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Your feedback is important to us. If you have
comments about this document, please send
them to
[e-mail]
Document No. 553148
Country of Origin: US
Page 2 of 2
Installing the Migration Backplane
for UC:
For UC migration, refer to the Fast Forward
Migration Manual (545-328) available on the
migration website for step-by-step
instructions to minimize labor costs and
customer down time.
WARNING:
This installation should only be done by a
qualified electrician or an authorized
Siemens Building Technologies
representative.
DANGER:
Shutting down the UC Panel may not
disconnect all high voltage I/O.
If no disconnect means are available use
the wire nuts supplied to protect exposed
terminals with voltage present.
Figure 1. Migration kit in UC Enclosure with PXC Compact.
Installing the Migration Backplane
for FLNC:
WARNING:
This installation should only be done by a
qualified electrician or an authorized
Siemens Building Technologies
representative.
1. Mount the migration backplane in the enclosure
using six ¾” long #6-32 hex standoffs provided.
2. Replace 4 existing hex standoffs in enclosure
with new supplied standoffs
3. Add 2 remaining standoffs to bottom of
backplane to provide additional support (these 2
will not screw down to enclosure.)
Figure 2. Migration kit in FLNC Enclosure with PXC Modular.