Operation Manual

30
Appendix
Gigaset A180-A185 / CAN us eng / A31008-M1970-R401-1-5819 / appendix.fm / 30.6.09
Specifications
Recommended batteries
Nickel-metal hydride (NiMH):
The handset is supplied with the author-
ized AAA batteries.
Handset operating times/charging
times
The operating and charge times apply only
when using the recommended batteries.
Base station power consumption
In standby mode: approx. 1.5 watts
During a call: approx. 2 watts
General specifications
The incoming call number is not displayed
through CID.
Caller ID is not enabled.
¥ You must ask the telephone network pro-
vider to activate Caller ID (CID).
You hear an error tone when keying an
input.
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the operating
instructions, if necessary.
You cannot listen to messages left on the
voice mailbox.
Your phone system is set for pulse dialing.
¥ Set your phone system to tone dialing.
You hear an error beep from the answering
machine during remote operation.
The system PIN entered is incorrect.
¥ Enter the system PIN again (see
page 27).
You cannot operate the answering machine
via remote operation.
Remote Access is not activated.
¥ Activate Remote Access (see page 20)
The answering machine does not record
messages/has switched to "announce only".
Its memory is full.
¥ Delete old messages.
¥ Play back new messages and delete.
Capacity 550 mAh
Standby time Approx. 300 hours
(12.5 days)
Talk time Approx. 10 hours
Charge time Approx. 10 hours
DECT 6.0 is supported
No. of channels 30 duplex channels
Radio frequency
range 1920–1930 MHz
Duplex method Time multiplex, 10 ms
frame length
Channel grid 1728 kHz
Bitrate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission
power
10 mW, average power per
channel
Range up to 984 feet outdoors,
up to 165 feet indoors
Power supply
input 110 V ~/60 Hz
Environmental
operating condi-
tions
+41°F to +113°F;
20% to 75% relative
humidity
Dialing mode DTMF (tone dialing)/DP
(pulse dialing)