Operation Manual

23
Using several handsets
Gigaset A180-A185 / CAN us eng / A31008-M1970-R401-1-5819 / registr_sett.fm / 30.6.09
Using several handsets
Registering handsets
You can register up to a total of six hand-
sets with your base station.
A Gigaset A18H handset can be registered
with up to four base stations.
Registering Gigaset A18H handset
On the handset
§Menu§ ¢ Settings ¢ Registration
¢ Register HS
q Select the base you want to
register your handset with and
press
§OK§. Bases that have
been registered will be marked
by ½.
~ Enter your PIN and press
§OK§
(default setting: 0000, see
page 27).
The handset will be registered.
On the base station
Within 60 seconds press and hold the reg-
istration/page key ÷ (for about 5 sec-
onds) on the base station (see page 2).
De-registering handsets
You can de-register any registered handset
from your Gigaset A180/Gigaset A185.
On a handset:
§Menu§ ¢ Settings ¢ Registration
¢ Unregister HS
~ Enter your PIN and press §OK§
(default setting: 0000, see
page 27).
q Select the handset you want to
de-register and press
§OK§.
§OK§ Press the display key to con-
firm deletion.
Locating a handset ("paging")
You can locate your handset using the
base station.
¤ Press the Registration/Paging key ÷
on the base station briefly.
¤ All handsets will ring at the same time
("paging"), even if the ring tones are
switched off.
On individual handsets you can press
the display key
§Quiet§ to mute the ring
tone.
Ending paging
¤ Briefly press the Registration/Paging
key on the base station ÷ or press
any key on the handset.
Changing the base station
If your handset is registered to more than
one base station, you can set it to a partic-
ular base station or to the base station
that has the best reception (Best Base).
§Menu§ ¢ Settings ¢ Registration
¢ Select Base
q Select one of the registered
base stations or Best Base and
press
§OK§.
Making internal calls
Internal calls to other handsets registered
with the same base station are free.
j Initiate internal call.
q Select the handset you want to
call and press
§OK§.
Note:
The base station and supplied handsets are
pre-registered at the factory.
Note:
If only two handsets are registered to the base,
the internal call will be established immedi-
ately after pressing
jkey.