Operation Manual

10
AL180 / IM-NORD EN / A31008-M2003-R201-1-9W19 / main.fm / 21.10.2008
Phone settings
For details on how to make audio settings, see
Menu tree
¢ p. 13.
For details on how to set the system PIN on the
base station, see the Menu tree
¢ p. 14.
Changing the display language
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK
¢ Language ¢ OK ¢ select the language ¢ OK
The current language is indicated by ‰.
If you accidentally choose a language you do not
understand:
MENU ¢ 4 2 1 (press the keys one after the other)
Select the correct language with u and press OK.
Resetting the handset
You can reset individual settings and changes that
you have made. Entries in the directory, the calls
list and the handset's registration to the base sta
-
tion will be retained.
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK
¢ Reset Handset ¢ OK
Cancel the reset with a.
Restoring the base station to the factory
settings
When restoring factory settings:
◆ All handsets are de-registered
◆ Individual settings are reset
◆ All lists are deleted
◆ The system PIN is reset to the original code
0000
Only the date and time are retained.
Software reset
MENU ¢ Settings ¢ OK ¢ Base ¢ OK
¢ Base Reset ¢ OK
Hardware reset
Disconnect the power cord from the base station.
Hold down the registration/paging key
(¢ p. 1)
on the base station while reconnecting the power
cable to the base station. Release the key after
approximately 5 seconds.
Repeater mode
With a repeater you can increase the range of your
base station. You will need to activate repeater
mode
(¢ p. 14). Repeater mode and Eco mode or
Eco mode+ (¢ p. 1) cancel each other out.
Operating the base station on the
PABX
The following settings are only necessary when
your PABX requires them, see the user guide for
your PABX.
When entering the digits, enter them slowly one
after the other.
Changing the dialling mode
MENU ¢ 4 I O 1 1 ¢ The number for the set dial-
ling mode flashes: 0 = touch tone dialling (DTMF);
1 = dial pulsing (DP) ¢ enter number ¢OK.
Setting recall
MENU ¢ 4 I O 1 2 ¢ The number for the current
recall flashes
: 0 = 80 ms; 1 = 100 ms; 2 = 120 ms;
3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms;
7 = 800 ms ¢ enter number ¢ OK.
Changing pause after line seizure
You can set the length of the pause inserted
between pressing the talk key
c and sending the
phone number.
MENU ¢ 4 I O 1 O ¢ The number for the current
pause length flashes: 1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.
¢ enter number ¢ OK.
Changing the pause after the recall key
MENU ¢ 4 I O 1 4 ¢ The number for the current
pause length flashes: 1 = 800 ms; 2 = 1600 ms;
3 = 3200 ms ¢ enter number ¢ OK.