User Manual

3 / 6
Siemens Handheld control AFK914/C01 CE1N2731en
Building Technologies 15.03.2010
Press the upper two buttons for 0.7 – 5 seconds to trigger a binding test. This
checks the radio link to the central apartment unit. The function LED signals the RF
binding test.
The handheld control goes to sleep mode when not used in a bound state.
Simultaneously press the upper two buttons for at least 20 seconds to reset the
AFK914/C01 to its delivery status. Afterwards it must be reintegrated into the
system.
The central apartment unit is notified after pressing a button when the AFK914/C01
battery is nearly empty and displays it. Battery capacity suffices for at least 100
actions when the maintenance message is displayed. All blue LED signal patterns
are replaced with yellow on the handheld control until the battery is replaced. The
yellow mix is created by simultaneously enabling the red and green LED.
Operating and display elements
2731Z15
2
1
3
4
Three-colored function LED
Overview of display and operating element functions on the AFK914/C01:
Function LED Button functions
• Battery level
• Binding process
• Confirmation message / Timeout
• Monitoring enabled; all monitored
windows and doors are closed
• Monitoring enabled; at least one
monitored window or door is
opened
• Monitoring disabled
Preset button functions
(Buttons 1 and 2 pressed simultaneously)
• Binding
• RF binding test
• Disconnect device from system
• Reestablish delivery status
Freely configurable button functions
(buttons 1 - 4)
• Enable / disable monitoring
• Trigger switching group command
• Trigger emergency alarm
• Trigger panic alarm
Additional information on the function and operation of the AFK914/C01 is available
in the product documentation for the central apartment unit.
RF binding test
Sleep mode
Delivery status
Error messages /
maintenance messages