User`s manual

2000590-001 Data Communications Setup •• 39
Editing the Address Translation Table, Continued
The Address Translation Table (ATT) can be displayed using the
Configuration Management routines.
1. Log on locally to the ANG_EN.
2. To display the entire ATT type at the Local >> prompt: display all
3. To display a single Loop only type: display adh x
Where x is the ADH Loop number. Allowable values are 1 - 8. If you
leave off the x value then the Loop number will default to the Loop
number of the local ANG_EN.
Displaying the ATT