User`s manual

Setting Network Address & Loop and Unit Numbers, Continued
Unit refers to a numeric number assigned to a
device on the Advance Data Hiway (ADH).
Typically an ANG device can have a unit number
from 0 to 31. However, If the ANG is connected to
an Advance Network Interface Unit (NIU), the
ANG unit number must not be set to 0.
unit:
The iproute variable defines the network path to
the default router. This value may be set to zero if
not used.
iproute:
Instructions
1. Log on locally to the ANG_EN.
The Connect Screen will appear with the log in information and the
local prompt. The local prompt indicates that you are communicating
with the ANG_EN connected directly to the PC.
2.0.1
Parameters entered below are not saved until the ANG_EN is reset!
Even though you are given the option to save after each entry you can
make all your entries and then reset to save your entries.
Learning Hint
2. To configure the ANG_EN IP address, at the Local > prompt type:
config address ip xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx should be replaced with the 12 digit unique
network address. See Assigning an IP (Internet Protocol) Address
page
37.
34 • Data Communications Setup 2000590-001