User`s manual

Data Hiway Connections, Continued
More Information
For technical information on the Data Hiway refer to Appendix A in the
Optichrom Advance Library Set, Volume 2, Board Installation and
Strapping Manual.
Instructions
Step Action
1. Place the ANG_EN AC Power Supply (Mains) circuit
breaker to OFF. On the ANG_EN Power Supply Assembly
place toggle ON/OFF switch to OFF.
WARNING
Placing the Power Supply Assembly toggle ON/OFF switch
to OFF does not remove the main voltage to the J1
terminals. To remove all input power to the ANG_EN, the
AC Power (Mains) to the ANG_EN needs to be shut off.
2. Route the Data Hiway cable to the ANG_EN in accordance
with national or local electrical codes and regulations; see
Figure 2-1.
To make the Data Hiway connections easier we have made it a
removable connector. Simply grasp the top portion of the connector and
pull it straight out from the base connector; see Figure 2-6.
Installation Note
Do not plug the Data Hiway connector in until you have set the loop and
unit number; see Chapter 3, Data Communications Setup.
CAUTION
2000590-001 Installation • 21