User`s manual

Wiring Connections
Description
All input ac power and communications connections are made to
connectors located on the chassis power supply assembly. To gain
access to the assembly, open the front panel of the ANG_EN. For Zone
1 units refer to the Figure 1-4, Zone 1 Outline Drawing.
Figure 2-4: Power
Supply/ANCB Assembly
A
dvance Data
Hiway
Port 1& 2
AC Power
Powe
r
ON/OFF
Switch
ANCB (Advance
Network
Communications
Board)
Ethernet
Port
I/O Wiring
Two removable wiring access plates permit all the wiring to be made
through the bottom section (wall units) or rear section (rack units) of the
ANG_EN. The plates can be punched to accommodate conduit or cable
gland connectors; see Figure 2-5. For Zone 1 units refer to the Figure
1-4, Zone 1 Outline Drawing.
Optional Conduit
Connection Box
If your wall mounted unit has a Conduit Connection box, holes must be
drilled into the side or bottom of the box to accommodate the moisture
protected cable glands or conduit fittings.
Figure 2-5: I/O Wiring
A
CCESS PLATES
Conduit Connection Box
Instructions
AC Power (Mains) Connections Page 18
Data Hiway Connections Page 20
Ethernet Connections Page 23
2000590-001 Installation • 17