User`s manual

2000591-001 Command Summary •• 71
Command Summary, Continued
The filter may also specify frames for a specific device by declaring the
device IP address. The device filter cannot be combined with the port
specification in a single command. To collect data from or to a device the
commands would look like:
trace 1 - Trace port # 1
trace 172.16.9.201 - Show messages from device 172.16.9.201
only
trace on - Enable tracing
The first command specifies the port #1 for trace data. The second
command filters the trace data to a single device’s frames, and the third
command enables tracing.
Finally, the trace parameters may be reset to their default values (tracing
all frames on the Ethernet port, without any address filtering) with:
trace reset
This command sets the time, in seconds, that the device will wait for the
“link validation” diagnostics to complete.
Validation timeout
With no parameters, the command dis-
plays the current link validation timeout
setting.
Validation timeout 10
Allows 10 seconds for the link diagnos-
tics to complete.
Validation timeout