User`s manual

68 •• Command Summary 2000591-001
Command Summary, Continued
Interface Statistics Received Sent
Bytes 1040 980568
Unicast packets 0 31
Non-unicast packets 10 5
Discards 0 0
Errors 0 0
Unknown protocols 0
The command netstat clear resets the Ethernet statistics counters.
The password command is used to change the user assigned password.
The password can be any alphanumeric character and it must be be-
tween five and twenty characters in length. Example:
password newpassword newpassword
Note the newpassword is entered twice to verify that the password was
entered correctly.
This command will enable or disable normal DataNET communication on
individual ports. Before placing a port into “test” mode (see test com-
mand below), the port must first be taken offline with:
port stop num
where num is a port number, 1 through 2.
port start num
Will re-start normal DataNET communications on a port.
This command resets and saves the configuration parameters in non-
volatile memory.
password
“port” Command
reset