User`s manual

2000591-001 Command Summary •• 61
Command Summary, Continued
This command adds a “local” ADH device to the Address Translation
Table. The Address Translation Table translates ADH addresses (Loop
& Unit) into IP addresses. “Local” indicates the ADH device is connected
directly to the Gateway’s ADH data bus.
add adh 1 5
This command adds ADH device Loop#1, Unit#5 to the Address Trans-
lation Table under the IP address of the Gateway.
This command sets the device IP address. Each device in the system
must have a unique IP address. Your TCP/IP network administrator can
help you choose appropriate addresses for your network. IP addresses
are entered in “dotted-decimal” notation. For example:
config address ip 192.10.6.123
The IP address is not automatically stored in non-volatile memory until
the reset command is entered. You can display the current IP address
with the config display command.
This command displays the configuration parameters for the device.
This command sets the IP subnet mask for the device. Your TCP/IP net-
work administrator can help you choose appropriate subnet mask for
your network. Subnet masks are entered in “dotted-decimal” notation.
For example:
config netmask 255.255.192.0
The subnet mask is not automatically stored in non-volatile memory until
the reset command is entered. You can display the current subnet mask
with the config display command.
add adh
config address ip
config display
config netmask