User`s manual

2000591-001 Data Communications Setup •• 53
Editing the Address Translation Table, Continued
5. To display a single Loop only type: display adh x
Where x is the ADH Loop number. Allowable values are 1 - 8. If you
leave off the x value then the Loop number will default to the Loop
number of the local ANG_EN.
6. To display the ATT by IP number type: display ip xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx is the IP address. If you leave off the IP ad-
dress, the IP portion will default to the value of the local ANG_DN.
Note: 255.255.255.255 and 0.0.0.0 are not allowed.