User`s manual

2000591-001 Data Communications Setup •• 47
Setting Network Address & Loop and Unit Numbers
This section provides instructions to configure an Advance Network
Gateway DataNET (ANG) with a network address. There are 4 levels of
addressing that must be set on each ANCB:
1. A factory set Ethernet address.
2. An assigned IP address for each ANCB board using a common Sub-
net-mask.
3. An assigned DataNET address that must be the same for both
ANCB board half.
4. An assigned Advance Data Hiway loop and unit address that must
be the same for both ANCB board half.
1. Connect a standard 9-pin COM cable from the designated PC COM
(see Figure 2-7) to one of the ANCB Configuration Ports.
2. Open Windows HyperTerminal program on your PC; reference Con-
figuring Your PC, page 40.
3. Connect and Log on to DNH; reference Establishing a Connection,
page 44.
Chapter 4, Command Line Summary, provides definitions for all of the
commands you will be using in this chapter.
1. Log on locally to the ANG.
The Connect Screen will appear with the login information and the
local prompt. The local prompt indicates that your are communicating
with the ANG connected directly to the PC.
Description
Before You Begin
Command Line
Definitions
Instructions