User`s manual

44 •• Data Communications Setup 2000591-001
Establishing a Connection
Once your PC is set up, as described in Configuring Your PC, you are
ready to connect to and configure the ANG_DN.
… read through this Chapter prior to performing any procedures.
The unit is a fully redundant unit with dual advance network communica-
tions boards (ANCB) and power supplies. Each half is assigned a chan-
nel designation (A or B) and an IP Address.
Each half to be configured as Channel A or Channel B
ANCB
Cross Link Cable
PC COM
Ports
1. Connect a standard 9-pin COM cable from the designated PC COM
port (Figure 2-7) to RS232 Configuration Port located on etiher
ANCB.
2. Turn on the AC power to the ANG.
The user interface program is password protected. This insures the data
integrity of all configuration data and limits unwanted access of the
User’s network. To access any of the programs you must logon with the
correct password.
Description
Getting Started
Dual System
Before You Begin
Password Protection