User`s manual

34 •• Installation 2000591-001
DataNET Fiber Optic Connections
The Fiber Optic Coupler is mounted in a threaded, potted, gas tight fitting
assembly designed for use in hazadrous areas when properly installed in
a approved enclosure. The ANG_DN uses two Fiber Optic Couplers, one
for Channel A, Port 2 (DataNET Channel A) and one for Channel B, Port
2 (DataNET Channel B).
All mounting hardware is supplied with the DataNET Fiber Optic ANG
parts kit. These parts are also available as spares and can be ordered
from us.
Description Part Number
Fiber Optic Coupler Assembly 2015828-001
Fiber Optics Coupler Seal Nut N8005
Fiber Optic Coupler Cable 2020947-001
The DataNET Fiber Optic Coupler performs translation of signals
between a DataNET Hub and a ANG_DN gateway. The Fiber Optic
Coupler converts between electrical signals and optical signals. The
conversion is transparent to the network. Fiber Optic signals are
impervious to distubances caused by electrical interference from nearby
equipment, ground loops, power surges, or nearby lightning strikes.
DataNET Fiber Optics Couplers can drive up to 5000 feet of fiber optic
cable.
Description
Required Parts
Fiber Optic Coupler