User`s manual

32 •• Installation 2000591-001
DataNET Copper Connections
The wiring method (conduit or cable glands) and which cable type you
use is dependent upon the site requirements. Review the Site Wiring
Requirements page 19 to ensure that you are using the correct cable
and wiring method.
Refer to ANCB Description page 74.
J12
J14
10Base2
10BaseT
J 10 Port 1
For ADH: Jumpers on
Top 3 Positions
J11 Port 2
For DataNET:Jumpers on
Bottom 3 positions
Config Port
RS232
57.6 KB
J2 Jumper Connections
•• •• 150 Ohm
•• ••
120 Ohm Port 2 (DN)
•• ••
100 Ohm
•• ••
150 Ohm
•• •• 120 Ohm Port 1(DN)
• • 100 Ohm
J2 not used for ANG-EN
Board
RESET
Operation
LEDS
J5
Default on Pins 1 &2
Step Action
1. Turn off AC Power (Mains) to the ANG.
WARNING
Placing the Power Supply Assembly toggle ON/OFF switch
to OFF does not remove the main voltage to the unit. To
remove all input power to the unit, the external AC Power
(Mains) to the unit needs to be shut off.
2. Route the DataNET copper cable to the ANG in accor-
dance with national or local electrical codes and regulations
via the holes drilled in the access plate; see Figure 2-1.
Before You Begin
Figure 2-7. ANCB Board
Jumper Settings
Instructions