User`s manual

2000591-001 Installation •• 25
AC Power (Mains) Connections
Each of the ANCB modules has a power supply assembly. The power
supply can accept inputs from 85-264 VAC, 47-63 Hz without the need
for setting switches or jumpers.
Advance Data Hiway Port 1 &
DataNET Port 2 Connector
AC Power
Connector
Power
ON/OFF
Switch
ANCB (Advance
Network
Communications
Board)
Depending upon the user configuration the power supplies can be con-
nected in parallel and powered from a single power source or they can
be powered from two independent power sources. In either case discon-
nects must be provided for each input power source.
The ANG should be installed in a rack or wall mount; see Wall or Rack
Mounting Installation; page 16. How you route the cable and wire to the
unit is dependent upon the site requirements. See Site Wiring Require-
ments (page 18) to determine the requirements for your site.
All wiring shall conform to the National Electrical Code (NEC) and/or
other national or local code requirements.
Step Action
1. Shut off the primary AC Power Supply lines to this location.
2. Open the door of the ANG by loosening the four captive
screws located on each corner; use a 4mm Allen wrench.
ANG Power Supply
ANCB Module
Installation Note
Before You Begin
Instructions