User`s manual

24 •• Installation 2000591-001
Wiring Connections
All input ac power and communications connections are made to con-
nectors located on each of the ANCB modules. To gain access to the
modules, open the front panel of the ANG. For Zone 1 units refer to the
Figure 1-4, Zone 1 Outline Drawing
Advance Data Hiway Port 1 &
DataNET Port 2 Connector
AC Power
Connector
Power
ON/OFF
Switch
ANCB (Advance
Network
Communications
Board)
Two removable wiring access plates permit all the wiring to be made
through the bottom section (wall units) or rear section (rack units) of the
ANG. The plates can be punched to accommodate conduit or cable
gland connectors. For Zone 1 units refer to the Figure 1-4, Zone 1 Out-
line Drawing.
ACCESS PLATES
IF you are wiring … THEN go to …
AC Power (Mains) Connections Page 25
Data Hiway Cable Connections Page 28
DataNET Connections Page 31
Description
Figure 2-4. ANCB Module
I/O Wiring
Figure 2-5. Wiring Access
Plate
Instructions