Troubleshooting guide

4-4 Optiset E Administrator Guide
Pause is used to enter a time delay into a Repdial sequence sent to the
communications server.
Flash and pause programming can be accomplished by putting the
Optiset E Liberator phone into Training mode and pressing the
Volume (for flash) or Channel (for pause) key on the handset. In the
Training mode, the Channel and Volume keys take on new
functionality.
To enter the
Training mode
➩
In Standby mode, press and hold the *, #,
and Talk keys simultaneously. You will
hear a beep tone when the phone enters the
Training mode.
To generate a
flash
➩
Press the Volume key.
To generate a
pause
➩
Press the Channel key. Note that each time
you press the Channel key, it is equivalent
to a 2 seconds time delay. For example, if
you want to add a 4 seconds delay, press
the Channel key twice.
To exit the Train-
ing mode
➩
Press the Talk key.
Muting the Handset
The Mute key turns off the microphone so that you can carry on a
conversation in the room without being heard by the other party on the
line. When using the Mute feature, the handset must be in Talk mode.
To mute the mi-
crophone
➩
Press the Mute key during the call. The
Talk icon blinks and the microphone line is
muted.
To resume con-
versation
➩
Press the Mute key again. The Talk icon
stops blinking and stays on.