Troubleshooting guide

2-12 Optiset E Administrator Guide
➩
Attach the connection cable to the Optiset
E Privacy Module.
➩
Insert the handset coil cable at the side of
the Optiset Privacy Module.
➩
Connect the link to the plug-type AC
adapter.
➩
Insert brief operating instructions in the
required language.
To put the Optiset
E Privacy Module
into service
➩
Connect the subscriber line to the
telephone.
➩
Plug the AC adapter into an outlet.
The Optiset E module automatically
performs a self-test when it is connected to
the power supply. The green LED flashes
during this self-test and lights up on
successful completion of the test. The
telephone with the optiset E Privacy
Module is now ready for operation.
Note:
If a fault is detected during the self-test, the green LED on the
Optiset E Privacy Module continues to flash on the
completion of the test.
This can occur if your handset is not yet connected to the
Optiset E Privacy Module.
— Disconnect the link to the AC adapter on the Optiset E
Privacy Module.
— Connect the Optiset E Privacy Module as described earlier.
— Reconnect the link to the AC adapter.
The Privacy Module operates as follows:
1) When the green “Ready” LED on the Privacy Module
is on, the module is ready for use.
2) User A calls user B.