Troubleshooting guide

Introduction 1-11
1. Introduction
Install the
handset battery
pack
➩
Remove the battery cover by pressing the
latch and sliding the cover down and off of
the handset.
➩
Slide the battery pack down into the
handset.
➩
Place the cover and slide the cover up until
it latches into the handset.
Charge the
handset battery
pack
➩
Place the handset in the front slot of the
charging unit.
➩
Make sure the CHARGE 1 indicator lights.
If the CHARGE 1 indicator does not light,
check to see that the AC adapter is plugged
in and that the handset is making good
contact with the charging unit charging
contacts.
It may take five to six hours to fully charge
the battery.
Charge the spare
battery pack
➩
Slide the spare battery pack into the second
slot in the charging unit until the retaining
clip snaps over the top of the pack.
➩
Make sure the CHARGE 2 indicator lights.
If the CHARGE 2 indicator does not light,
check to see that the AC adapter is plugged
in, and that the battery pack is making good
contact with the charging unit charging
contacts. Also, if the CHARGE 2 indicator
does not light, it is possible that the battery
is already fully charged.
➩
It may take five to six hours to fully charge
the battery. When charging is complete,
press out on the latch and remove the
battery pack for use. Or, if you do not need
the battery pack immediately, leave it in
the charging compartment; it will not
overcharge.