Troubleshooting guide

5-42 Optiset E Administrator Guide
To set up a
station speed key
on a display
telephone
➩
When your phone is idle, press the Menu
key.
➩
Scroll to
Program/Service?
and select it.
➩
Select
Change destinations?
.
➩
Scroll to
Station speed dial?
and select it.
Enter index:
will be displayed, for the
station speed dialing code.
➩
Dial the code you want to use (0 through 9,
or 00 through 29 if you are set up for more
than 10 codes).
Enter new number
: will be displayed.
➩
Dial the sequence you want the code to
dial.
Note:
On the Optiset E Liberator
telephone, if you need to add a delay or a
flash into your dialing sequence, refer to
“Flash and Pause” on page 4-3.
If you make an error while entering the
dialing sequence, press the Clear key to
cancel your changes and the enter the
sequence again. Or scroll to
Cancel?
and
select it.
➩
Select
Save?
➩
To end setup, select “Exit?.
OR
➩
Press the Program key.
➩
Dial 13.
➩
Dial the code you want to use.
➩
Dial the sequence you want the code to
dial.