Operating Instructions

Commissioning (basic settings)
Limit switching: set
50 | 80
A6V12052002
Select parameter
◈
Select parameter either:
● click using the menu to parameter, or
● using direct display: press and enter ID M0084.
Display indicates: Set end pos. CLOSED?
CLOSED or OPEN
1. Use the Up ▲ Down ▼ buttons to select:
● Set end pos.CLOSED? M0084
● Set end pos. OPEN? M0085
The black triangle ▶ indicates the current selection.
2. Press Ok.
The display indicates either:
● Set end pos.CLOSED? CMD0009 → continue with Step 9.
● Set end pos. OPEN? CMD0010 → continue with Step 12..
● Specialist (4) → continue with step 6
Log on user
1. Use the Up ▲ Down ▼ buttons to select the user:
Information: Required user level: Specialist (4) or higher
Symbol descriptions:
● -black triangle: ▶ = current setting
● -white triangle: ▷ = selection (not saved yet)
2. Press Ok to confirm to selected user.
Display indicates: Password 0***
◈
Enter password (→ enter password).
The display indicates either:
● Set end pos.CLOSED? CMD0009 → continue with Step 9.
● Set end pos. OPEN? CMD0010 → continue with Step 12.
Set end position CLOSED CMD0009
Reset end position CLOSED:
● For large strokes: Set selector switch in position Local control (LOCAL) and
operate actuator in motor operation using push button (CLOSE) in direction of
the end position.
Information: Stop the actuator before reaching end of travel (press STOP push
button to avoid damage.
● Engage manual operation.
● Turn the handwheel until valve is closed.
● Turn the handwheel by approximately half a turn (overrun) in the opposite
direction of end position.
● Set selector switch to the 0 (OFF) position.
Display indicates: Set end pos.CLOSED? Yes No
1. Press Yes to accept new end position setting.
Display indicates: End pos. CLOSED set!
The left LED is illuminated (standard version) indicating that the end position CLOSED
setting is complete.