Operating Instructions

Indications
Indications in the display
A6V12052002
39 | 80
Warnings (S0005)
If a warning has occurred, the display shows S0005:
● the number of warnings occurred
● a blinking question mark after approximately 3 seconds
Figure 34: Warnings.
For further information, see <Corrective action>.
Not ready REMOTE (S0006)
The S0006 display shows indications of the Not ready REMOTE group.
If this indication has occurred, the display shows S0006:
● the number of indications occurred
● a blinking crossbar after approximately 3 seconds
Figure 35: Not ready REMOTE indications.
For further information, see <Corrective action>.
Fault (S0007)
If a fault has occurred, the display shows S0007:
● the number of faults occurred
● a blinking exclamation mark after approximately 3 seconds
Figure 36: Fault.
For further information, see <Corrective action>.
Status indications according to NAMUR recommendation
These indications are available, if the parameter Diagnostic classification M0539 is set
to NAMUR.
Out of Specification (S0008)
The S0008 indication shows out of specification indications according to NAMUR
recommendation NE 107.
If this indication has occurred, the display shows S0008: