Operating Instructions

Indications
Indications in the display
A6V12052002
37 | 80
Figure 29: Units of torque
Display in percent
100% indication equals the maximum torque indicated on the name plate of the
actuator.
Example: SA 07.6 with 20 to 60 Nm.
● 100% corresponds to 60 Nm of nominal torque.
● 50% corresponds to 30 Nm of nominal torque.
Operation commands (S0003)
The display S0003 indicates:
● active operation commands, for example: Operation in the CLOSE or OPEN
direction.
● the actual value E2 as bar graph indication and as value between 0 and 100%.
● for setpoint control (positioner): setpoint E1
● for stepping mode or for intermediate positions with operation profile: pivot points
and operation behavior of pivot points
The navigation support (bottom row) fades out after approximately 3 seconds and the
axis/axes for pivot point display are shown.
OPEN - CLOSE control
Active operation commands (OPEN, CLOSE, ...) are shown above the bar graph
display. The figure below shows the operation command in the CLOSE direction.
Figure 30: Display for OPEN - CLOSE control
E2 Actual position value
Setpoint control
If the positioner is enabled and activated, the bar graph indication for E1 (position
setpoint) displays.
An arrow above the bar graph indication displays the direction of the operation
command. The figure below shows the operation command in the CLOSE direction.
Figure 31: Indication for setpoint control (positioner)
● E1 Position setpoint
● E2 Actual position value