User's Manual

Waveform Display Screens
Waveform display screens allow you to display the output of a Waveform
Recorder module. They read the data from this module’s Wform Log output
register and display it graphically based on the scale you define. Depending
on how the waveform is formatted, your display may contain from 1 to 8
cycles of waveform data:
Waveform
Format
Cycles Appearing
on MGT
Resolution
(samples/cycle)
128 x 14
1 128
64 x 14, 64 x 28
264
32 x 12, 32 x 26,
32 x 40, 32 x 54
432
16 x 22, 16 x 48,
16 x 72, 16 x 96
816
As the MGT can only display 128 points at a time, it takes the most recent
set of waveforms in the Wform Log output register.
To set up a waveform display screen:
1. Enter the handle of a Waveform Recorder’s Wform Log output register,
then press
ENTER. If you want to keep the register that is currently in
use, press the button labeled
KEEP PREVIOUS.
2. Enter a title of up to 15 characters, then press the
ENTER button. To keep
the title that is currently in use, press the button labeled
KEEP PREVIOUS.
The register label is
displayed (or the register
name if no label has been
setup).
The title of the screen
is displayed here.