Printer User Manual

Forms layout IBM Proprinter emulation
Programmer Reference Guide U26169-J-Z716-1-7600
© Siemens Nixdorf Informationssysteme AG 1995 Pfad: D:\SNI\Mackwitz\u26169\o26169e\26169E.K04
Set form length in inches
This command specifies the physical page length in inches and sets the current vertical
position as the first print line (top of form).
p
1
Form length in inches
Set perforation skip mode
The perforation area is specified as a number of lines at the current line spacing. It is
skipped at the end of every page.
The perforation area is not affected by later changes of the line spacing.
The perforation area should be selected so that at least
4
/
6
inch remain as print area.
If you change the first line (top of form), the perforation area moves accordingly.
p
1
Perforation area in lines at the current line spacing
Control sequence Hexadecimal Decimal
ESC C NUL p
1
1B 43 00 p
1
27 67 00 p
1
Range: X’01 ≤ p
1
≤ X’16
The minimum valid form length is 3 inches and the
maximum is 22 inches.
Control sequence Hexadecimal Decimal
ESC N p
1
1B 4E p
1
27 78 p
1
Range: X’00 ≤ p
1
≤ X’FF