Printer User Manual

Select barcode Barcodes
Programmer Reference Guide U26169-J-Z716-1-7600
© Siemens Nixdorf Informationssysteme AG 1995 Pfad: D:\SNI\Mackwitz\u26169\o26169e\26169E.K06
p
3
Specification of bar height; bar height = p
3
x
1
/
12
inch. A decimal whole number with
one or two digits (from 1 to 99) can be specified.
EAN and UPC codes with add-on code (EAN Add-On 2 or EAN Add-On 5)
require a minimum height of
3
/
12
inch.
These values change with the degree of saturation of the ribbon. They are thus only valid
for a new ribbon.
The module width is standardized with the EAN and UPC codes. The following values are
valid for p6 when setting the barcode:
1)
SC 3, SC 6 and SC 9 refer to the DIN standard.
The ratio of wide to narrow is fixed with Code 93, MSI Mod 10/10 and Code 128. p
6
is thus
not required and is ignored. POSTNET does not require the parameters p
4
, p
5
and p
6
.
Value of
decimal
place
p
4
Width of bar
Code direction
horizontal vertical
p
5
Width of space
Code direction
horizontal vertical
p
6
Ratio of
wide to
narrow
0 0.35 mm 0.28 mm 0.35 mm 0.28 mm 2.0 to 1
1 0.53 mm 0.42 mm 0.53 mm 0.42 mm 2.5 to 1
2 0.70 mm 0.56 mm 0.70 mm 0.56 mm 3.0 to 1
3 0.88 mm 0.70 mm 0.88 mm 0.70 mm 3.5 to 1
4 1.05 mm 0.85 mm 1.05 mm 0.85 mm ---
5 1.23 mm 0.99 mm 1.23 mm 0.99 mm ---
6 1.41 mm 1.12 mm 1.41 mm 1.12 mm ---
7 1.58 mm 1.27 mm 1.58 mm 1.27 mm ---
p
6
= 0
p
6
= 1
p
6
= 2
p
6
= 3
Size: SC 3
1)
Size: SC 6
1)
Size: SC 9
1)
Size: SC 3
1)
!