User manual

SITOP UPS1600 / UPS1100
Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
97
Mounting/removal
4
4.1
UPS1600
WARNING
Installing the device in a housing or a control cabinet
The SITOP UPS1600s are built-in units. They must be installed in a housing or control
cabinet where only qualified personnel have access.
The device can be snapped onto a standard mounting rail EN 60715 35×7.5/15 for mounting
in a control cabinet.
Mounting
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult, press slider
⑩ at the same time, as described under "Removal".
Removal
To remove, carefully open the slider ⑩ using a screwdriver or by hand (see Figure 4-1
Removal (example 6EP4136-3AB00-2AY0) (Page 97)) and disengage the device at the
bottom edge of the standard mounting rail. Then you can remove the device from the upper
edge of the standard mounting rail.
Figure 4-1 Removal (example 6EP4136-3AB00-2AY0)