User manual

Engineering
3.5 SITOP UPS Manager
SITOP UPS1600 / UPS1100
84 Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
Behavior depending on the battery charge
Make the settings under "Software configuration > Battery charge".
The following options are available:
● Start the application when the battery charge > 85% of the maximum
● Start the application when the battery charge < 85% of the maximum
● Open SITOP UPS Manager when the battery charge > 85% of the maximum
● Open SITOP UPS Manager when the battery charge < 85% of the maximum
Behavior depending on the remaining buffer time
Make the settings under "Software configuration > Remaining buffer time "Buffer mode not
possible". Specify the minimum buffer time under "Hardware configuration > Base device" in
entry "Buffer time".
The following options exist in the "Remaining buffer time" submenu:
● Start the application if the desired buffer time cannot be achieved
● Start the application when the desired buffer time can be achieved again
● Open the SITOP UPS Manager if the desired buffer time cannot be achieved
● Open the SITOP UPS Manager when the desired buffer time can be achieved again
Behavior for interrupted communication with the UPS1600
Make the settings under "Software configuration > Communications interface".
The following options are available:
● Start the application if the connection to the UPS1600 is interrupted
● Start the application when the connection to the UPS1600 exists again
● Open the SITOP UPS Manager when the connection to the UPS1600 exists again
● Open the SITOP UPS Manager if the connection to the UPS1600 is interrupted
Behavior for pending system alarms
Make the settings under "Software configuration > System alarms". Reasons for a system
alarm are contained in the alarms list (see Section Alarm list (Page 38)).
The following options exist in the "System alarms" submenu:
● Start the application if at least one system alarm is pending
● Start the application if no further system alarms are pending
● Open the SITOP UPS Manager if at least one system alarm is pending
● Open the SITOP UPS Manager if no further system alarms are pending