User manual

Engineering
3.5 SITOP UPS Manager
SITOP UPS1600 / UPS1100
Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
83
Behavior during buffer mode
Make the settings under "Software configuration > Buffer mode".
The following options are available:
● Start application on power failure
● Start application on power return
● Display SITOP UPS Manager on power failure
● Display SITOP UPS Manager on power return
● Shut down PC on power failure
Note
CAUTION: If the buffer time (see Section
Configuring the UPS1600 (Page 80)) is set shorter
than this time, the DC UPS switches off before the PC is shut down. The PC is then no
longer protected.
Behavior for missing buffer readiness
Make the settings under "Software configuration > Buffer mode not possible".
The following options are available:
● Start the application if buffer mode is not possible
● Start the application when buffer readiness returns
● Open the SITOP UPS Manager if buffer mode is not possible
● Open the SITOP UPS Manager when buffer readiness is available again
Behavior when battery replacement required
Make the settings under "Software configuration > Battery replacement".
The following options are available:
● Start the application if battery replacement is recommended (from SITOP UPS Manager
V4.12.5 and higher)
● Start the application when the battery replacement is completed
● Open the SITOP UPS Manager if battery replacement is recommended (from SITOP
UPS Manager V4.12.5 and higher)
● Open the SITOP UPS Manager when the battery replacement is completed