User manual

Engineering
3.3 STEP 7 in the TIA-Portal
SITOP UPS1600 / UPS1100
50 Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
Preconditions
● The UPS1600 has been correctly connected, and connected with the system.
● PG/PC with STEP 7 in the TIA Portal is connected with the system.
Proceed as follows
1. From the toolbar, open the "Online > Accessible nodes" menu.
2. As type of PG/PC interface, select "PN/IE".
3. Select the PG/PC interface connected with the system.
4. Select the connection with the subnet, in which the UPS1600 device is located.
All of the available UPS1600 devices in the selected subnets are displayed.
5. Select the required UPS1600.
6. Activate the "Flash LED" checkbox.
7. Check at which UPS1600 in the system the "SF" LED flashes.
By checking the flashing LEDs, you can uniquely identify all UPS1600 in a system. Note the
device name and the IP address of the desired UPS1600 in order to load a configuration.
Changing the device name of the UPS1600
1. In STEP 7 in the TIA Portal in the tabular area of the Network view select tab "Network
overview".
2. Overwrite the name in the "Device" column in the row of the PROFINET device involved.
The name is adapted in the graphical area of the network view.
Changing the device name of the UPS1600 using the properties of the PROFINET interface
You can change the PROFINET name using the properties of the PROFINET interface.
1. Select the PROFINET interface of a PROFINET device in the Network or Device view of
the Hardware and Network editor of STEP 7 in the TIA Portal.
2. In the Inspector window navigate to "Ethernet addresses" in the "PROFINET" area.
3. Deactivate the "Generate automatically the PROFINET device name" checkbox.
4. Enter the new PROFINET device name in the appropriate field.