User manual

Engineering
3.3 STEP 7 in the TIA-Portal
SITOP UPS1600 / UPS1100
46 Operating Instructions, 05.2014, C98130-A7628-A1-4-7629
3.3.4
UPS1600 and UPS1100 parameters in Step 7 in the TIA Portal
The adjustable parameters of the UPS1600 and the UPS1100 battery modules used can be
found in STEP 7 in the TIA Portal in theInspector window under Properties if the
corresponding device was selected. The "Basic device", "Energy storage" and "Web server"
parameters are relevant. These tabs and their subgroups are shown in the table below.
Tab
Subgroup
Description
Basic unit
Buffering
All parameters that affect the behavior of the UPS for buffering.
Signaling
Setting of the alarm signaling and the wait time for stable input voltage.
Battery maintenance
intervals
Maintenance interval for the deployed batteries.
Energy storage
–
Parameters for the deployed battery modules.
Web server General information Specification whether access to the UPS via Web server is permitted
(yes/no).
A detailed description of the individual parameters of the subgroups is contained in the
associated section under Parameterizing the UPS in STEP 7 in the TIA Portal (Page 46).
3.3.5
Parameterizing the UPS in STEP 7 in the TIA Portal
The procedure is the same for all parameters. This section describes the general procedure
to reach the configuration dialog. The individual parameters and their possible values are
described in the following subsections.
Each parameter has a start value. A click on "Reset to initial values" resets all parameters of
a subgroup to the associated start value.
Preconditions
● The UPS1600 was integrated in the project that has been opened